The Jalopy Journal
Its a long story. Were some of the guys there from the car club that built it? Was it the River Rats or something like that?
Any of you guys there see the "Oly Rock" or hear the story about it?
Had a guy try to convince me to run this in our fleet trucks. http://www.wsbindustries.com/ Take a look at the engine oil additive. Never heard...
Head for Shedd every thursday afternoon to early evening. Just a bunch of good ole boys hanging out like it should be. Nothing fancy but worth...
Yea, I got a pair. They are usually in my wife's purse tho.
Truck driver says to the mechanic "I got a bad leak, I think I blew a seal" Mechanic says "I hope you washed your mouth out."
Yea, me too. Same thoughts on the car also.
Thanks for the suggestions. I will look into the blocks, just wasn't sure if the springs could tolerate it or not. I would like to achieve...
I looked at doing a z on the frame but it would screw up my cab mounting. The front hanger is just about at the back of the cab. I will take a...
The springs are 1 3/4" wide. Anybody have any ideas for springs? Seems like all the ones I see available are either 2 or 2 1/2 inches wide....
So another '35 IH pickup followed me home the other day. My plan is to run the full fenders and running boards. So the help I need is getting it...
Mickey Thompson did quit a bit with magnesium. I saw a SBC engine block made from mag in his daughters shop. Only two ever made by GM. I think...
Try this again. Picture didn't show up before. This was on the wall in the bathroom at a place in Spokane Washington called Milford's....
Don't remember any C-6 trans. Before the 727 was the earlier auto that was just an fmx. Almost all of the parts between the IH and Ford FMX...
Can't port the heads too much. You start getting into the water passages if I remember right. Might be an oil galley, not sure' but I do...
One more thing. You only have to change the hoses, not the regulators.
Propylene/Propane is great for cutting steel. It leaves very little if any slag. Compared to Acetylene, it does not weld worth a crap. Can't get...
Not true. International was building crewcab trucks for years. Although anything prior to 1961 was a three door on pickups. The trucks and...
My list could go on forever. The two that have always stood out for me though were.......... Studebaker Hawk, I would hope a silverhawk or...
I shot some candy red over red flake. The candy seemed make the flakes "pop" fade out. I stripped it and started over. Went with a silver...
Anybody have any more pictures of "El Lobo"? I love that thing.
I have a set of extra door and both have wood and metal posts. Dont have my doors chopped yet. I got one of them chopped but the just the shell....
On my IH I didn't change any window angles. I only went 2" tho and more would look, well, more betta. I like his chop better than mine and...
I only went 2" on mine. What are you doing for the floor? I got a 312 Y block in mine and it sits right up against the cowl. Had to cut out a...
Next softball helmet I'm going to try the Rattle Bomb cans.
Here it its.
I saw some rattle cans of flake on Ed Roth web site. Google Roth metal flake see what comes up. I did my daughters softball helmet in red....
Before, and so far.
I remember as a kid getting gas there with my parents in their 68 Ford Torino. I was alway excited to drive past that thing, the high light of...
U put the end with the cap and rotor in the block????????? :) Binder Planet has a tremendous amount of know ledge on these things.
Separate names with a comma.