The Jalopy Journal
Quite a perfect project. I yike it!
Yes I agree with the above.. Most applications show the linkage on the right side. Most stock tradition carbs with linkages are on the right side....
I’ve had good results when using nylon hose material over the carbs mouth and then place a frogs mouth over it to hold in place. They last a long...
Shoulda 8 It
Try this question on Fordbarn. https://www.fordbarn.com/forum/forumdisplay.php?f=4
The Ohio picture may give some clues. Campbell Ohio is very near Youngstown and I found this with his name search....
Stock ford 94 not rebuilt = 20-35 bucks Rebuild kit = 40 bucks Knowledge = priceless. Or consider a GM or Electronic conversion
What a beauty. Great job. That’s a keeper for sure. I’d love to get to drive it.
Last year going down we by-passed Atlanta pulling my 40 ft trailer. We took the route west of that mad mess. Mostly two and some four lanes, some...
Don’t laugh. This stuff is cheap and I’ve seen it do miracles. [ATTACH]
Wow. How cool. Thanks for sharing Mark. I’d take that 61 in a heartbeat.
What a solid start you have Kevin. Your bed sides look to be in really good shape. The firewall is original with a new skin welded to the outside....
Moriarity will surely send you in the right direction. Quite a few here have built these trucks. We will all help you here too. Yes start a...
[ATTACH] I insulated the back side of the firewall on my 34. And installed windlace along the leading edge of the doors slong with the doors top...
Run NGK’s the best plugs in the business. Your engine will use. NGk B6L or B4L depending on the heat you chose
You know I’ve rarely every remember seeing much spam on Fordbarn.
I wonder if AI is related to this shit. This is nuts. :(
Awful news. Terrible thing to have to deal with. Hope all goes well.
Be careful guys…. When you share the hotel room, you’ll learn why he calls himself “big daddy”.
Larry, You’ve won my heart in just one short post. I’m glad you’re on the hamb with us.
If it were me, I’d look for a nice project Henry 32. Preferably mechanically sound. Then go from there. You’re about to dig up a gigantic rabbit...
Yes remove the studs and apply permatex sealant on each stud. When torquing the heads to the proper pounds, be sure to follow the correct...
Thx tub. Anyone else tried them…..
I was looking for a good replacement plug for my used Mercury 2 stroke outboard and was wonder how these NGk (surface gap) plugs would behave in a...
I used this stuff too. Acrylic enamel with a gloss hardener. Holding up well. 15 yrs old now. [ATTACH] [ATTACH]
I’ve had bad luck with spray on adhesives. Started used brush on Dap and never looked back.
Most flash burns from experience welders come by hitting the side of your eyes. We never realize or notice them. Wearing glasses with darkened...
Your stock distributor will not allow you to use dual carbs. That setup must be attached to ONE Holley94. Dual carbs won’t provide the proper...
I’d guess on the top of the left frame rail But according to these guys it varied…. https://www.fordbarn.com/forum/showthread.php?t=162941
It sounds like you have a dead short problem. Check your wiring as it enters through the bottom point plate. Check your condenser and points wire...
Separate names with a comma.