The Jalopy Journal
1973 Santa Pod England...Side by side again with the Shoe? [ATTACH]
Removeable section for long tube style in two place Thunderbird... [ATTACH] [ATTACH] [ATTACH]
How about the Redhill UK version before you go to sleep tonight?...Sweet dreams! [MEDIA]
Cruisin' not cruise in!!! [MEDIA]
I believe the car hails from Sweden. Picture of engines stolen from facebook page of Nick Pettitt. Over 300 pictures of the event including...
Frame and running gear all 1955 Thunderbird. Story and details from when I first got it can be viewed...
How about a Galaxie built for two?....."The Spinster".... [ATTACH] [ATTACH] [ATTACH]
And the contents... [ATTACH]
How could you resist with packaging like this... [ATTACH] [ATTACH] [ATTACH]
For me it's hard lines only, with AC style glass bowl filter. Remember a steadying brace near the filter. [ATTACH] [ATTACH] [ATTACH]
Glory days, well they'll pass you by... [ATTACH] [ATTACH]
Here is a little inspiration... go for it! [MEDIA]
[ATTACH] [ATTACH] [ATTACH] If Ford had stayed with aligning the Thunderbird styling to that of the full size lineup then by 1963 it might have...
1st SUV....[ATTACH] [ATTACH]
No! No! it's not DEAD.... It's just resting!!!
Rocky, you are right about water in the oil, but it had only been there for a few minutes. One of the rocker stand bolts had gone into the water...
In order for the piston to move freely through the cylinder bore pressure has to be applied to the center of the piston evenly throughout the...
If the oil problem is really caused by a blocked galley and not worn bearings then this method will usually clear it. Remove rocker shaft and...
Valley pan with valve and grommet installed in draft tube location. This pan happens to be the elusive "E" code variant, note indented top...
2 out of 3[ATTACH]
I suspect you are working with a cross drilled center journal camshaft, as opposed to the later grooved one. If so then turn the engine a few...
If you have to have a scoop, it has to be Little Bird, [ATTACH]
The ball bearings referred to are located on the outer circumference of the breaker plate and when they seize up, and they do, the only part...
No pre tour cleanup here. Sorry for the mess. [MEDIA]
If grounding the gauge deflects the needle to cold then that implies that the needle rests on hot with ignition off. If that is the case then you...
The bare K&N looked out of place, so..... [ATTACH]
Does anybody have a vacuum switch for sale? (see pic) Need one to complete installation. (see pic)[ATTACH] [ATTACH]
Totally different distributors with totally different breaker plates with totally different mounting plates attached to module. Will not fit.
No... it will not fit. You will need a new one.
1956 Chris Craft....[ATTACH]
Separate names with a comma.